FIG. 6A depicts an example message sequence for IAB-node 1 to establish an RRC connection, followed by F1-AP* connection. It is assumed that IAB-node 1 has been pre-configured (or configured by the network) with information that instructs how to select a cell served by the IAB-donor. As shown in the figure, IAB-node 1—in an idle state (RRC_IDLE)—may initiate an RRC connection establishment procedure by sending Random Access Preamble to the IAB-donor, which may be received and processed by the DU of the IAB-donor. Upon successful reception of Random Access Response from the IAB-donor, IAB-node 1 may send a RRCSetupRequest, followed by reception of an RRCSetup and transmission of RRCSetupComplete. At this point of the message sequence, the IAB-node 1 may enter a connected state (RRC_CONNECTED) with the IAB-donor, and may proceed with a security procedure to configure encryption/integrity protection features. The CU of the IAB-donor may further send an RRCReconfiguration to IAB-node 1, which may comprise configuration parameters to configure radio bearers (e.g., data radio bearers (DRBs) and signaling radio bearers (SRBs)). In some embodiments, the RRCReconfiguration is sent to modify an RRC connection and establish Radio Connection between a UE and the network, however, in the present embodiment, the RRCReconfiguration may also be sent to configure a connection between an IAB-node and the network. RRC Connection Reconfiguration messages may be used to, for example, establish/modify/release Radio Bearers, and/or perform handover, etc. In one embodiment, any of the RRC messages transmitted from IAB-node 1 may include information identifying the IAB-node 1 as an IAB-node (not as a UE). For example, the Donor CU may be configured with a list of node identities (e.g., IMSI or S-TMSI) that may be allowed to use the service from the donor. The information may be used by the CU in the subsequence operations, for example, to distinguish a UE from an IAB-node.
